Mosin Nagant Scope Mount: We offer two types of scope mounts for the mosin nagant rifles. When ordering, please verify the type receiver that is on your rifle ( Hex or Round) before you place your order.  Our scope mounts are made from 6061 aluminum and coated with a special hard coating that reduces chipping and scratching as well as being resistant to salt spray corrosion.  Along with your scope mount you can also purchase an optional bolt handle. Our bolt handles are machined from a solid piece of steel and are designed specifically for our scope mounts. Our scope mounts come with 3 mounting screws, allen wrench and detailed installation instructions on how to install the scope mount. Our scope mounts have 3 mounting points... Two on the top forward part of the receiver and one on the left side of the receiver in the stripper clip guide area. Our scope mounts use the same top two mounting points as some similar mounts on the market. There is no stock inletting needed unless you are using a Boyd's replacement stock. You may need to do some light sanding around the receiver area. Our Mosin Nagant scope mount design allows the shooter to get a lower, more proper cheek weld and places the scope closer for better eye relief. It also supports the rear of the scope to eliminate movement for improved accuracy unlike other mounts that either have no rear support or place the scope too high for a proper check weld. We have tested our scope mounts up to 800 yards with sub MOA results. Try that with your mount. 

Mosin Nagant Bolt Handle: This can be purchased separately without the scope mount. It is machined from a solid piece of steel and designed specifically for the Mosin Nagant Rifle. The Bolt handle installation does require welding and comes with detailed installation instructions. You will also need to inlet the stock for the handle unless you are using an ATI aftermarket stock. Our bolt handle design keeps a very low profile on the rifle and is angled toward  the trigger for  faster cycling of the bolt.   $29.99

Mosin Nagant Bolt Body with Handle: This can be purchased separately without the scope mount. The bolt handle is machined from a solid piece of steel and designed specifically for the Mosin Nagant Rifle and has been TIG welded to a surplus Mosin Nagant bolt body. You will  need to inlet the stock for the handle unless you are using an ATI aftermarket stock. Our bolt handle design keeps a very low profile on the rifle and is angled toward  the trigger for  faster cycling of the bolt.  $69.99